Parameter List - Mitsubishi Q2ACPU User Manual

13.

PARAMETER LIST

13 PARAMETER LIST
The parameters set for the QnACPU are listed in the table below.
For details on each parameter, refer to the section or reference manual indicated.
Item
PLC name
Label
Comment
PLC system
Low-speed timer
Timer limit setting
High-speed timer
RUN-PAUSE contacts
Remote reset
Output at STOP RUN
Common pointer No.
General data processing
Points occupied by empty slot
Interrupt counter
System interrupt
Fixed scan interval
PLC file
File register
Comment file used in a command
Initial device value
File for local device
Parameter No.
Set labels and/or comments for peripheral devices on the CPU
– module.
This setting does not affect CPU module operation.
0000 Set a label for the CPU module.
H
0001 Set a comment for the CPU module.
H
Make various settings that are required for the CPU module
–
system.
1000 Set the low-speed or high-speed timer limit.
H
1000 Set the contact to control RUN/PAUSE of the CPU module.
H
1002 Enable or disable the remote reset operation.
H
1003 Set the output mode for switching from STOP to RUN.
H
1005 Set the first common pointer number.
H
Set the number of modules that are processed in one general data
1006
H
processing.
1007 Set the number of points occupied by empty slots.
H
Set the first interrupt counter number, and the fixed scan interval for
1008
H
the interrupt pointer.
– Set various kinds of files used by the CPU module.
1100 Set a file register file to be used.
H
1101 Set a comment file used in an instruction.
H
1102 Set a file for initial device values to be used.
H
1103 Set a file for local devices to be used.
H
13 - 1
Description