Mitsubishi Q2ACPU User Manual page 534

APPENDICES
Error Code
Error
(Hexadecimal)
4080
H
4081
H
4082
H
4083
H
4084
H
4085
H
Other error
4086
H
4087
H
4088
H
4089
H
408A
H
408B
H
Error Contents
Data error
The searched target cannot be
detected.
The designated command cannot
be performed since it is in
execution.
An attempt was made to perform a
program not registered in the
parameters.
The designated pointer P, I cannot
be detected.
Pointer P, I designation is not
possible because the program is
not registered in the parameters.
An attempt was made to add a
pointer P, I that have already
existed.
The number of pointers
designated is too great.
The designated step No. is not at
the head of the instruction.
The END instruction was inserted/
deleted while the CPU module
had been in RUN.
The file capacity has been
exceeded by performing write
during RUN.
Cannot perform a remote request. Data error.
Message Displayed
at Peripheral Device
Data is faulty.
Cannot find the find target.
Unable to execute due to on
going process.
Not registered.
Cannot find the find target.
Not registered.
Device ranges are duplicated.
No pointer exists.
Execution position is incorrect.
Setting is incorrect.
File capacity is not enough.
App - 137
Corrective Action
Check the requested data
contents.
Check the data to be searched.
Re-perform the command after
requests from other devices has
been completed.
Register the program to be
performed to the parameters.
Check the data to be searched.
Register the program to be
performed in the parameters, then
designate the pointer P, I.
Check the pointer No. to be added
and change it.
Check and correct the designated
pointer.
Check and correct the designated
step No.
Insert/Delete the instruction after
setting the CPU module to STOP.
Set the CPU module to STOP and
then write the program.
Set the CPU module to the state
for performing a remote request,
then reissue the request.