13. PARAMETER LIST
Default value
–
No setting
No setting
–
100ms
10ms
No setting
Disabled
Before operation
No setting
1 module
16 points
No setting
I28
100ms
I29
40ms
I30
20ms
I31
10ms
–
Not used
Not used
Use the same file name as the
program.
Not used
Setting
Setting range
–
Up to 10 characters
Up to 64 characters
–
10ms to 1000ms (in 10ms units)
1ms to 100ms (in 1ms units)
X0 to X1FFF
Enabled/disabled
Before operation/After 1 scan
P0 to P4095
1 to 6 modules
0 point to 64 points (in 16-point units)
C0 to C65535
5ms to 1000ms (in 5ms units)
–
• Not used
• Use the same file name as the program.
• Use the following file.
• Not used
• Use the same file name as the program.
• Use the following file.
• Not used
• Use the same file name as the program.
• Use the following file.
• Not used
• Use the following file.
13 - 2
Reference Section/Reference Manual
Section 11.2
–
QnACPU Programming Manual (Fundamentals)
Section 10.6.1, Section 10.6.3
Section 10.6.4
Section 10.4
QnACPU Programming Manual (Fundamentals)
Section 6.3
Section 5.3
QnACPU Programming Manual (Fundamentals)
–
QnACPU Programming Manual (Fundamentals)
Section 11.5
QnACPU Programming Manual (Fundamentals)
QnACPU Programming Manual (Fundamentals)