Error Code List (7000 To 10000) - Mitsubishi Q2ACPU User Manual

22. TROUBLE SHOOTING

22.3.9 Error code list (7000 to 10000)

Error
Error Contents and Cause
Code
[F**** ]
Annunciator (F) was set ON
■Collateral informationmmon
9000 • Common Information:Program error location
• Individual Information:Annunciator number
■Diagnostic Timing
• When instruction executed
[<CHK>ERR ***-***]
Error detected by the CHK instruction.
■Collateral informationmmon
• Common Information:Program error location
9010
• Individual Information:Failure No.
■Diagnostic Timing
• When instruction executed
*2 For the Basic model QCPU, the special register (SD207 to DS209) for LED indication priority can turn off the indication. (The LED indication is always OFF
for the High Performance model QCPU, Process CPU, Redundant CPU, and Universal model QCPU.)
The following shows the error messages from the error code 7000 to 10000, the
contents and causes of the errors, and the corrective actions for the errors.
Read the individual information of the error using
the peripheral device, and check the program
corresponding to the numerical value (annunciator
number).
Read the individual information of the error using
the peripheral device, and check the program
corresponding to the numerical value (error
number) there.
Corrective Action
22 - 44
LED Status Corresponding
CPU Status CPU
RUN:
On
ERR.:
*2
On/Off
CPU Status:
Continue
RUN:
USER LED On
ERR.:
USER LED On
CPU Status:
Continue
QnA
RUN:
On
ERR.:
Off
CPU Status:
Continue
RUN:
USER LED On
ERR.:
USER LED On
CPU Status:
Continue