Mitsubishi Q2ACPU User Manual page 240

13. PARAMETER LIST
Item
Device
Device points
Latch (1) start (Enable C/L key)
Latch (2) start (Disable C/L key)
Local device
PLC RAS
WDT setting
Initial execution
WDT setup monitoring time
Low speed execution
monitoring time
Error check
Operating mode when there is an error
Constant scan
Display F No.
Annunciator
Comment display
display mode
Time of occurrence
Breakdown history
Low speed program execution time
Parameter No.
– Set the number of points, latch range, etc., for each device.
2000 Set the number of device points used.
H
2001 Set the latch range for which latch clear key operation is enabled.
H
2002 Set the latch range for which latch clear key operation is disabled.
H
2003 Set the range of devices to be set as local devices.
H
– Set various kinds of settings for the RAS function.
3000 Set the watchdog timer for the CPU module.
H
3001 Set whether to detect the specified errors or not.
H
Set the operation mode in which the CPU module enters when an
3002
H
error is detected.
3003 Set the constant scan time.
H
Set the display mode that is activated when an annunciator comes
3004
H
ON.
3005 Set where the CPU module breakdown history is stored.
H
Set the time required for execution of low-speed execution type
3006
H
programs.
13 - 3
Description