Mitsubishi Q2ACPU User Manual page 536

APPENDICES
Error Code
Error
(Hexadecimal)
40A0
H
40A1
H
40A2
H
SFC device
40A3
H
designation
error
40A4
H
40A5
H
40A6
H
40B0
H
40B1
H
SFC file-
related error
40B2
H
40B3
H
4A00
H
Link-related
4A01
H
error
4A02
H
Target-
4B00
H
related error
Error Contents
Out-of-range block No. is
designated.
Designation exceeds the range for
the number of blocks.
Out-of-range step No. is
designated.
Designation exceeds the range for
number of steps.
Out-of-range sequence step No. is
designated.
The designated device is out of
range.
The block designation pattern or
step designation pattern was
incorrect.
The designated drive is incorrect.
The designated program does not
exist.
The designated program was not
an SFC program.
The SFC dedicated instruction
exists in the write during RUN
area.
The designated station cannot be
accessed because no routing
parameters have been set to the
relevant station.
No network with the No. set in the
routing parameters exists.
Cannot access to the designated
station.
An error occurred at the access
target station or the relay station.
Message Displayed
at Peripheral Device
Setting is incorrect.
Setting is out of range.
Setting is incorrect.
Setting is out of range.
Setting is incorrect.
Setting is out of range.
Setting is incorrect.
Setting is incorrect.
The file name does not exist.
This file cannot be handled.
Setting is incorrect.
Routing parameter does not
exist.
The network I/O does not
exist.
Link unit error.
The corresponding unit is
faulty.
App - 139
Corrective Action
Check and correct the set
contents.
Check and correct the set number.
Check and correct the set
contents.
Check and correct the set number.
Check and correct the set
contents.
Check and correct the set number.
Check and correct the set
contents.
Check and correct the set
contents.
Check and correct the designated
file name.
Check and correct the designated
file name.
Check and correct the set
contents.
Set the routing parameters for
accessing to the designated
station in the relevant station.
Check and correct the routing
parameters set at the relevant
station.
Check if an error has occurred at
the network module/link module,
or if the online state has not been
established.
Check and correct the error at the
designated access target station
or the relay station for the access
station.