Using Auto Discovery For Initial System Configuration - 3Com NBX 100 Installation Manual

164 C 3: I
HAPTER NSTALLING
Using Auto
Discovery for Initial
System
Configuration
NBX 100 H C
ARDWARE OMPONENTS
Figure 43 Regional Setting Details
This is a partial display of Regional Software Details. You can scroll the
message bar to see the complete report.
After completing the hardware installation test, you are ready to begin
configuring the system. Using Auto Discovery simplifies initial system
configuration by adding information about new devices to the
configuration database. Devices include telephones, Line Card ports,
Digital Line cards, DSS/BLF adjuncts, as well as "virtual devices" that exist
on the network such as the pcXset PC Telephone Client and the
ConneXtions H.323 Gateway.
At this point in the installation process, Auto Discovery adds the Line Card
ports and DIgital Line cards you've installed.
After a device has been discovered, the Auto Discovery process does not
find that device again. If you remove the device from the system, you
must use NetSet to manually remove the device and thereby remove the
database record.