3Com NBX 100 Installation Manual page 103

Dial Plan Configuration File Commands 103
TableEntry Create
Description:
Creates an entry in a Dial Plan table that specifies a string of digits to
compare to dialed digits. If the Dial Plan table entry already exists, this
command overwrites it with the new information. Dial Plan table entries
control the actions when dialed digits and table entry digits correspond
properly. Dial Plan table entries specify both the class of the resulting call
(for Class of Service restriction) and the route the call should take.
Syntax:
TableEntry Create nDialPlanTableId nEntryId szDigits
nMinDigits nMaxDigits szCallClass nPriority nRouteId
Arguments:
nDialPlanTableId — An integer in the range 1through 32768. The NBX
100 reserves three ID numbers:
1 — Internal Dial Plan table
2 — Incoming Dial Plan table
3 — Least Cost Routing table
nEntryId — An integer in the range 1 through 32768. Each entry must
have a unique ID. If two entries have the same ID, the system uses the
entry closer to the bottom of the configuration file (the one processed
last).
szDigits — A string of dialed digits in a Dial Plan entry.
nMinDigits — An integer specifying the minimum number of digits to
collect.
nMaxDigits — An integer specifying the maximum number of digits to
collect.
szCallClass — The call class for this Dial Plan entry. The call class
corresponds to permissions granted to users in their Class of Service. The
list of possible values is: Internal, Local, LongDistance, International,
WAN, TollFree, Emergency, COCode, Wireless, Other, Toll, AlternateLong,
Operator, TrunkToTrunk, Diagnostics, NotAllowed.