Modifying The Span - 3Com NBX 100 Installation Manual

248 C 7: C
HAPTER ONFIGURING

Modifying the Span

D L C (T1, E1,
IGITAL INE ARDS
6 To change the name of the T1 board, edit the contents of the Board
Name field.
To connect the T1 line and activate the span perform these steps.
1 Plug the T1 line into the NBX 100 T1 board.
2 The Card Type field should already contain ISDN PRI. If it does not, select
ISDN PRI from the pull-down list.
3 Click Apply.
To check that the Span status changes from Offline to Ready, perform
these steps.
1 Return to the Digital Line Cards tab.
2 Select ISDN PRI Span List from the Select Device Type list.
3 Click Apply.
4 Check that the word Ready appears in the ISDN PRI Span List line item
that corresponds to this span.
To modify the Span, highlight it in the Span List and click the Modify
button immediately below the Span List.
Figure 94 Digital Line Cards, Modify Span Window
BRI C )
AND ARDS