How To Configure Site-To-Site Ipsec Vpn With Microsoft (Ms) Azure - ZyXEL Communications ZyWALL 110 Handbook
Zywall/usg series security firewalls
Hide thumbs
Also See for ZyWALL 110:
- User manual (1090 pages) ,
- Handbook (749 pages) ,
- Handbook & instructions (255 pages)
Table of Contents
Advertisement
Figure 344 MONITOR > Log
If you see that Phase 1 IKE SA process done but still get below [info] log message, please check
2
ZyWALL/USG and SonicWALL Phase 2 Settings. Both ZyWALL/USG and SonicWALL must use the
same Protocol, Encapsulation, Encryption, Authentication method and PFS to establish the IKE SA.
Figure 345 MONITOR > Log
Make sure the both ZyWALL/USG and SonicWALL security policies allow IPSec VPN traffic. IKE uses
3
UDP port 500, AH uses IP protocol 51, and ESP uses IP protocol 50.
Default NAT traversal is enable on ZyWALL/USG, please make sure the remote IPSec device must
4
also have NAT traversal enabled.
4.7 How to Configure Site-to-site IPSec VPN with Microsoft
(MS) Azure
This example shows how to use the VPN Setup Wizard to create a site-to-site VPN between a
ZYWALL/USG and a Microsoft (MS) Azure platform. The example instructs how to configure the
VPN tunnel between each site. When the VPN tunnel is configured, each site can be accessed
securely.
Figure 346
Chapter 4 Create Site-to-Site VPN Tunnels
ZyWALL Site-to-site IPSec VPN with Microsoft (MS) Azure
ZyWALL/USG Series User's Guide
151
Advertisement
Table of Contents
