Figure 314 VPN > Branch Office VPN > Gateway > Phase 1 Settings
Use Transform Settings to create the same security settings as in the ZyWALL/USG Phase 1
6
settings. Click OK and Save to exit the Transform Settings page.
Figure 315 VPN > Branch Office VPN > Gateway > Phase 1 Settings > Transform Settings
Then, go to VPN > Branch Office VPN > Tunnel to add a Tunnel Route Settings. In the Local IP
7
section, set the Network IP to be the IP address range of the network connected to the
WatchGuard. In the Remote IP section, set the Network IP to be the IP address range of the
network connected to the ZyWALL/USG. Click OK.
Figure 316 VPN > Branch Office VPN > Tunnel > Address
Chapter 4 Create Site-to-Site VPN Tunnels
ZyWALL/USG Series User's Guide
139