How To Configure L2Tp Vpn With Ios 8.4 Mobile Devices; Set Up The L2Tp Vpn Tunnel On The Zywall/Usg - ZyXEL Communications ZyWALL 110 Handbook

Verify that the Zone is set correctly in the Zone object. This should be set to IPSec_VPN Zone so
7
that security policies are applied properly.
5.3 How to Configure L2TP VPN with iOS 8.4 Mobile
Devices
This example shows how to use the VPN Setup Wizard to create a L2TP VPN between a ZyWALL/
USG and an iOS 8.4 Mobile Device. The example instructs how to configure the VPN tunnel
between each site. When the VPN tunnel is configured, each site can be accessed securely and
allow traffic from L2TP clients to go to the Internet.
Figure 512 ZyWALL/USG L2TP VPN with iOS Mobile Devices Example
Note: All network IP addresses and subnet masks are used as examples in this article.
Please replace them with your actual network IP addresses and subnet masks. This
example was tested using USG310 (Firmware Version: 4.13) and iOS (Firmware
Version: 8.4).

5.3.1 Set Up the L2TP VPN Tunnel on the ZyWALL/USG

In the ZyWALL/USG, go to CONFIGURATION > Quick Setup > VPN Setup Wizard, use the VPN
1
Settings for L2TP VPN Settings wizard to create a L2TP VPN rule that can be used with the
remote iOS Mobile Devices. Click Next.
Figure 513 Quick Setup > VPN Setup Wizard > Welcome
Chapter 5 Create Client-to-Site VPN Tunnels
ZyWALL/USG Series User's Guide
215