ZyXEL Communications ZyWALL 110 Handbook page 136

Figure 306 Quick Setup > VPN Setup Wizard > Wizard Type > VPN Settings (Configuration)
This screen provides a read-only summary of the VPN tunnel. Click Save.
5
Figure 307 Quick Setup > VPN Setup Wizard > Welcome > Wizard Type > VPN Settings (Summary)
Now the rule is configured on the ZyWALL/USG. The Phase 1 rule settings appear in the VPN >
6
IPSec VPN > VPN Gateway screen and the Phase 2 rule settings appear in the VPN > IPSec
VPN > VPN Connection screen. Click Close to exit the wizard.
Figure 308 Quick Setup > VPN Setup Wizard > Wizard Type > VPN Settings > Wizard completed
Go to CONFIGURATION > VPN > IPSec VPN > VPN Gateway, click Show Advanced
7
Settings. Configure Authentication > Local ID Type as IPv4 and set the Content as your
ZyWALL/USG's WAN IP Address (in the example, 172.101.30.73). Then, configure
Authentication > Remote ID Type as IPv4 and set the Content as your WatchGuard's External
IP Address (in the example, 172.100.30.63). Click OK.
Chapter 4 Create Site-to-Site VPN Tunnels
ZyWALL/USG Series User's Guide
136