Set Up The Lan Ipv6 Interface On The Zywall/Usg - ZyXEL Communications ZyWALL 110 Handbook
Zywall/usg series security firewalls
Hide thumbs
Also See for ZyWALL 110:
- User manual (1090 pages) ,
- Handbook (749 pages) ,
- Handbook & instructions (255 pages)
Table of Contents
Advertisement
Figure 640 ZyWALL/USG with IPv6-in-IPv4 Tunnel Example
Note: All network IP addresses and subnet masks are used as examples in this article.
Please replace them with your actual network IP addresses and subnet masks. This
example was tested using USG310 (Firmware Version: ZLD 4.13).
6.3.1 Set Up the LAN IPv6 Interface on the ZyWALL/USG
In the ZyWALL/USG, go to CONFIGURATION > Network > Interface > Ethernet > lan1.
1
Select Enable Interface and Enable IPv6. Type 2002:7a64:dcee:1::111/128 in the IPv6
Address/Prefix Length field for the LAN1's IP address.
Enable Router Advertisement. Then click Add in the Advertised Prefix Table to add
2002:7a64:dcee:1::/64. The LAN1 hosts will get the network prefix through the router
advertisement messages sent by the LAN1 IPv6 interface periodically. Click OK.
Figure 641 CONFIGURATION > Network > Interface > Ethernet > lan1 > General Settings
Chapter 6 Configure IPv6
ZyWALL/USG Series User's Guide
269
Advertisement
Table of Contents
