Zyxel One Network (Zon) Utility - ZyXEL Communications ZyWALL 110 User Manual

The following table describes the labels in this screen.
Table 321 Configuration > System > IPv6
LABEL
Enable IPv6
Apply
Reset

36.16 ZyXEL One Network (ZON) Utility

The ZyXEL One Network (ZON) utility uses the ZyXEL Discovery Protocol (ZDP) for discovering and
configuring ZDP-aware ZyXEL devices in the same broadcast domain as the computer on which
ZON is installed.
The ZON Utility issues requests via ZDP and in response to the query, the ZyXEL device responds
with basic information including IP address, firmware version, location, system and model name.
The information is then displayed in the ZON Utility screen and you can perform tasks like basic
configuration of the devices and batch firmware upgrade in it. You can download the ZON Utility at
www.zyxel.com and install it on a computer.
The following figure shows the ZON Utility screen.
Figure 500 ZON Utility Screen
In the ZON Utility, select a device and then use the icons to perform actions. The following table
describes the icons numbered from left to right in the ZON Utility screen.
Table 322 ZON Utility Icons
ICON
1 IP configuration
2 Renew IP
3 Reboot Device
4 Flash Locator LED
5 Web GUI
Chapter 36 System
DESCRIPTION
Select this to have the ZyWALL/USG support IPv6 and make IPv6 settings be
available on the screens that the functions support, such as the Configuration >
Network > Interface > Ethernet, VLAN, and Bridge screens. The ZyWALL/USG
discards all IPv6 packets if you clear this check box.
Click Apply to save your changes back to the ZyWALL/USG.
Click Reset to return the screen to its last-saved settings.
DESCRIPTION
Change the selected device's IP address. This is not supported by the ZyWALL/
USG at the time of writing.
Update a DHCP-assigned dynamic IP address. This is not supported by the
ZyWALL/USG at the time of writing.
Use this icon to restart the selected device(s). This may be useful when
troubleshooting or upgrading new firmware.
Use this icon to locate the selected device by causing its Locator LED to blink. This
is not available on the ZyWALL/USG at the time of writing.
Use this to access the selected device web configurator from your browser. You will
need a username and password to log in.
ZyWALL/USG Series User's Guide
717