Set Up The L2Tp Vpn Tunnel On The Zywall/Usg - ZyXEL Communications ZyWALL 110 Handbook
Zywall/usg series security firewalls
Hide thumbs
Also See for ZyWALL 110:
- User manual (1090 pages) ,
- Handbook (749 pages) ,
- Handbook & instructions (255 pages)
Table of Contents
Advertisement
Figure 530 ZyWALL/USG L2TP VPN with Remote Windows 10 Client Example
Note: All network IP addresses and subnet masks are used as examples in this article.
Please replace them with your actual network IP addresses and subnet masks. This
example was tested using USG310 (Firmware Version: 4.13) and Windows 10 Pro
(Version: 10.0.10240)
5.4.1 Set Up the L2TP VPN Tunnel on the ZyWALL/USG
In the ZyWALL/USG, go to CONFIGURATION > Quick Setup > VPN Setup Wizard, use the VPN
1
Settings for L2TP VPN Settings wizard to create a L2TP VPN rule that can be used with the
Window 10 clients. Click Next.
Figure 531 Quick Setup > VPN Setup Wizard > Welcome
Then, configure the Rule Name and set My Address to be the wan1 interface which is connected
2
to the Internet. Type a secure Pre-Shared Key (8-32 characters).
Figure 532 Quick Setup > VPN Setup Wizard > Welcome > VPN Settings
Chapter 5 Create Client-to-Site VPN Tunnels
ZyWALL/USG Series User's Guide
222
Advertisement
Table of Contents
