Set Up The Ssl Vpn Tunnel On The Zywall/Usg - ZyXEL Communications ZyWALL 110 Handbook

Note: All network IP addresses and subnet masks are used as examples in this article.
Please replace them with your actual network IP addresses and subnet masks. This
example was tested using USG1900 (Firmware Version: ZLD 4.13).

5.8.1 Set Up the SSL VPN Tunnel on the ZyWALL/USG

In the ZyWALL/USG, go to CONFIGURATION > VPN > SSL VPN > Access Privilege to add an
1
Access Policy. Configure a Name for you to identify the SSL VPN configuration.
Figure 618 CONFIGURATION > VPN > SSL VPN > Access Privilege > Access Policy > Configuration
Go to Create new Object > User to add User Name (SSL_VPN_1_Users in this example) and
2
Password (4-24 characters, zyx168 in this example), click OK.
Figure 619 CONFIGURATION > VPN > SSL VPN > Access Privilege > Access Policy > Create new
Object > User
Go to Create new Object > Application to add servers that you will allow SSL_VPN_1_Users to
3
access. Click OK.
Chapter 5 Create Client-to-Site VPN Tunnels
ZyWALL/USG Series User's Guide
256