Hub_Hq-To-Branch_B - ZyXEL Communications ZyWALL 110 Handbook
Zywall/usg series security firewalls
Hide thumbs
Also See for ZyWALL 110:
- User manual (1090 pages) ,
- Handbook (749 pages) ,
- Handbook & instructions (255 pages)
Table of Contents
Advertisement
Figure 412 CONFIGURATION > VPN > IPSec VPN > VPN Connection > General Settings and VPN
Gateway
Click Create new Object on the upper bar to add the address range of the local network behind
3
Hub_HQ to Branch_B and an address of local network behind Branch A.
Figure 413 CONFIGURATION > VPN > IPSec VPN > VPN Connection > Create new Object
Set Local Policy to be HQ-to-Branch_A and Remote Policy to Branch_A which are newly
4
created. Click OK.
Figure 414 CONFIGURATION > VPN > IPSec VPN > VPN Connection > Policy
4.8.11 Hub_HQ-to-Branch_B
Go to CONFIGURATION > VPN > IPSec VPN > VPN Gateway, select Enable. Type the VPN
1
Gateway Name used to identify this VPN gateway.
Then, configure the Secure Gateway IP as the Branch B's Gateway IP address (in the example,
172.16.30.1). Type a secure Pre-Shared Key (8-32 characters) which must match your Branch
B's Pre-Shared Key and click OK.
Chapter 4 Create Site-to-Site VPN Tunnels
ZyWALL/USG Series User's Guide
178
Advertisement
Table of Contents
