Test The Ipsec Vpn Tunnel - ZyXEL Communications ZyWALL 110 Handbook
Zywall/usg series security firewalls
Hide thumbs
Also See for ZyWALL 110:
- User manual (1090 pages) ,
- Handbook (749 pages) ,
- Handbook & instructions (255 pages)
Table of Contents
Advertisement
Figure 249 Quick Setup > VPN Setup Wizard > Welcome > Wizard Type > VPN Settings (Summary)
Now the rule is configured on the ZyWALL/USG. The Phase 1 rule settings appear in the VPN >
6
IPSec VPN > VPN Gateway screen and the Phase 2 rule settings appear in the VPN > IPSec
VPN > VPN Connection screen. Click Close to exit the wizard.
Figure 250 Quick Setup > VPN Setup Wizard > Welcome > Wizard Type > VPN Settings > Wizard
Completed
Go to CONFIGURATION > VPN > IPSec VPN > VPN Gateway and click Show Advanced
7
Settings. Configure Authentication > Peer ID Type as Any to let the ZyWALL/USG does not
require to check the identity content of the remote IPSec router.
Figure 251 CONFIGURATION > VPN > IPSec VPN > VPN Gateway > Show Advanced Settings >
Authentication > Peer ID Type
4.2.3 Test the IPSec VPN Tunnel
The Site-to-site VPN with Dynamic Peer can only initiate the VPN tunnel from the peer has a
1
dynamic IP Address. Go to CONFIGURATION > VPN > IPSec VPN > VPN Connection, click
Connect on the upper bar. The Status connect icon is lit when the interface is connected.
Chapter 4 Create Site-to-Site VPN Tunnels
ZyWALL/USG Series User's Guide
115
Advertisement
Table of Contents
