Set Up The Ipsec Vpn Tunnel Of Zywall/Usg Without Using Vpn Concentrator; Hub_Hq-To-Branch_A - ZyXEL Communications ZyWALL 110 Handbook
Zywall/usg series security firewalls
Hide thumbs
Also See for ZyWALL 110:
- User manual (1090 pages) ,
- Handbook (749 pages) ,
- Handbook & instructions (255 pages)
Table of Contents
Advertisement
4.8.9 Set Up the IPSec VPN Tunnel of ZyWALL/USG without Using VPN
Concentrator
4.8.10 Hub_HQ-to-Branch_A
Go to CONFIGURATION > VPN > IPSec VPN > VPN Gateway and select Enable. Type the VPN
1
Gateway Name used to identify this VPN gateway.
Then, configure the Secure Gateway IP as the Branch A's Gateway IP address (in the example,
172.16.20.1). Type a secure Pre-Shared Key (8-32 characters) which must match your Branch
A's Pre-Shared Key and click OK.
Figure 411 CONFIGURATION > VPN > IPSec VPN > VPN Gateway
Go to CONFIGURATION > VPN > IPSec VPN > VPN Connection and select Enable. Type the
2
Connection Name used to identify this VPN connection. Select scenario as Site-to-site and VPN
Gateway which is configured in Step 1.
Chapter 4 Create Site-to-Site VPN Tunnels
ZyWALL/USG Series User's Guide
177
Advertisement
Table of Contents
