Output Sample Port Connector 'J9' (Type 'N' Female) - Comtech EF Data TRP1000-OD Installation And Operation Manual

Pin
A RS485_+RX
B RS485_-RX
C RS485_+TX
D RS485_-TX
E RS232_RD
F ENET
G RS232_TD
H ENET
J Not Used
K Gnd
L SUM_FLT_In
M SUM_FLT_Out
N Not Used
P Not Used
R Not Used
S System Mute Control
T Gnd
U ENET
V ENET
2.2.5

Output Sample Port Connector 'J9' (Type 'N' Female)

System Connections, Installation and Startup
Table 2-2. Connector 'J6 | COMM 1' Pin Assignments
Name
Ask Mark K about TX and RX being switched vs 500W GaAs manual and
TX+
CSI Spec
TX-
Conecting this pin to Gnd (Pin K) will cause the SUM_FLT_Out relay to
activate (i.e. connects pin m to pin k)
When faulted, tied to Pin K, else open
System muted if customer ties to Pin K
RX-
RX+
The output Sample Port connector is found on the left-hand side of the front
chassis. It is a Type 'N' female connector that provides a nominal -50 dB sample
of the output signal. A calibration label, provided near the connector, shows the
actual coupling values vs. frequency.
TRP1000-4450 Troposcatter C-Band Outdoor Amplifier
Description
2–5
Revision 0
MN-TRP1000-OD