Comtech EF Data TRP1000-OD Installation And Operation Manual page 13

Troposcatter c-band outdoor amplifier
Table of Contents

Advertisement

I nstallation Guidelines Regarding Power Line Quality
4 B 4 B
Comtech EF Data has become familiar with the varying quality of the AC
power grid around the world. Observing the following installation guidelines
should help ensure a reliable installation.
Surge suppression: High voltage surges can cause failure of the power supply. These surges
are typically caused by circuit switching on the main AC power grid, erratic generator operation,
as well as lightning strikes. The TRP1000 does not have built in surge suppression; therefore,
regardless of power grid quality at the point of installation, Comtech EF Data recommends
installation of additional power conditioning/surge suppression at the power junction box.
Grounding: The TRP1000 provides a grounding terminal. This is provided to allow grounding of
the TRP1000 to the antenna's grounding network. All installed components should be grounded
to a common grounding point at the antenna.
Electrical welding: If welding needs to take place at the antenna, disconnect all cables from the
TRP1000 except for the ground wire. Cap all RF connections with terminations. This will prevent
damage to the input/output circuitry of the amplifier.
Lightning: Lightning strikes on or around the antenna will generate extremely high voltages on
all cables connected to the TRP1000. Depending on the severity of the strike, the external surge
suppression may protect the TRP1000's power supply. However, if the installation will be in an
area with a high probability of lightning strikes, Comtech EF Data recommends the installation of
surge suppression on the RF and IF cables. One source of these suppressors is PolyPhaser
(
w ww.polyphaser.com).
2 H
W arranty Policy
5 B 5 B
Comtech EF Data products are warranted against defects in material and workmanship for a
specific period from the date of shipment, and this period varies by product. In most cases, the
warranty period is two years. During the warranty period, Comtech EF Data will, at its option,
repair or replace products that prove to be defective. Repairs are warranted for the remainder of
the original warranty or a 90 day extended warranty, whichever is longer. Contact Comtech EF
Data for the warranty period specific to the product purchased.
For equipment under warranty, the owner is responsible for freight to Comtech EF Data and all
related customs, taxes, tariffs, insurance, etc. Comtech EF Data is responsible for the freight
charges only for return of the equipment from the factory to the owner. Comtech EF Data will
return the equipment by the same method (i.e., Air, Express, Surface) as the equipment was sent
to Comtech EF Data.
All equipment returned for warranty repair must have a valid RMA number issued prior to return
and be marked clearly on the return packaging. Comtech EF Data strongly recommends all
equipment be returned in its original packaging.
Comtech EF Data Corporation's obligations under this warranty are limited to repair or
replacement of failed parts, and the return shipment to the buyer of the repaired or replaced
parts.
Preface
TRP1000-4450 Troposcatter C-Band Outdoor Amplifier
xi
Revision 0
MN-TRP1000-OD

Advertisement

Table of Contents
loading

Table of Contents