Comtech EF Data TRP1000-OD Installation And Operation Manual page 84

Command
(Instruction
Parameter
Type Code and
or Response
Qualifier)
Gateway
IPG= 15 bytes
Address
Initialize ISP= None
Statistics
Pointer
Lamp Test LAM= 1 byte
Retrieve next
N/A 145 bytes
5 unread
Stored
Alarms
Serial-based Remote Product Management
Arguments
for
Description of Arguments
Command (Note that all arguments are ASCII
numeric codes between 48 and 57)
to Query
Command or Query.
Used to set the Gateway IP address for the 10/100 Base Tx
Ethernet management port, in the format:
xxx.xxx.xxx.xxx,
Where:
xxx.xxx.xxx.xxx is the IP address
Example:
<1/IPG=192.168.001.005'cr'
>0001/IPG='cr''lf'
Default Value: 192.168.001.005
Command only.
Resets internal pointer to allow RNS? Queries to start at the
beginning of the statistics log.
Example:
<1/ISP='cr'
>0001/ISP='cr''lf'
Command or Query.
Lamp test mode,
Where:
0 = Disable
1 = Enable (all front panel LEDs are lit)
Example:
<0001/LAM=1'cr'
>0001/LAM=1'cr''lf'
Default Value: 0
Query only.
See RNE query.
TRP1000-4450 Troposcatter C-Band Outdoor Amplifier
Response to
Command
(Target to
Controller)
IPG=
IPG?
IPG*
ISP=
ISP?
ISP*
LAM=
LNA=
5–16
Revision 0
Query Response
(Instruction to Query
Code and (Target to
Qualifier) Controller)
IPG =
IPG?
xxx.xxx.xxx.
xxx
N/A N/A
LAM? LAM=x
See RNE
LNA?
query
MN-TRP1000-OD