4.5.4.3.2
Config | Mask
Use this page to configure TRP1000-4450 mask parameters.
Each pull down menu has three sections: MASKED, ALARM, FAULT.
•
MASKED does not generate a ALARM or FAULT.
•
ALARM may generate an Alarm (does not set the Summary Fault Relay).
•
FAULT may generate an Fault (does set the Summary Fault Relay).
All Alarms and Fault are recorded in the Event log.
•
RF Module Fan 1 Speed
•
RF Module Fan 2 Speed
•
RF Module Fan 3 Speed
•
PS Module Fan 1 Speed
•
PS Module Fan 1 Speed
•
PS Module Fan 1 Speed
•
High Input Power
•
High Reverse Power
•
Low Forward Power
Click [Change Alarm Mask] to save changes. Otherwise, click [Reset] to revert to the previously
assigned Alarm Mask settings.
Click [Refresh] to update the page with the current viewing and operating configuration.
Ethernet-based Remote Product Management
TRP1000-4450 Troposcatter C-Band Outdoor Amplifier
Figure 4-6. Config | Utility Page
4–16
Revision 0
MN-TRP1000-OD