Connector 'J9 | Output Sample' (Ps 2 Only); Connectors 'J10 | Modem Rx' And 'J11 | Lnb' (Optional Interfaces); 2.2.8 Ground Connector; Figure 2-4. Lpod Ground Connectors - Comtech EF Data LPOD Installation And Operation Manual

LPOD Outdoor Amplifier / Block Up Converter
System Connections, Installation and Startup

2.2.6 Connector 'J9 | OUTPUT SAMPLE' (PS 2 Only)

2.2.7 Connectors 'J10 | MODEM Rx' and 'J11 | LNB' (Optional Interfaces)

PS 1 / PS 1.5 – J10 (left), J11 (right)
PS 2 – J10 (left), J11 (right)

2.2.8 Ground Connector

A #10-32 stud is provided at the locations shown in Figure 2-4 for connecting a
common chassis ground among equipment.
The 'J9 | OUTPUT SAMPLE' port is a Type 'N' female connector
available only on the PS 2 model. It provides a nominal -40 dB
sample of the output signal. A calibration label is provided near
the connector that shows the actual coupling values vs.
frequency.
The 'J10 | MODEM Rx' and 'J11 | LNB' ports are
both Type 'N' female connectors, providing both bias
and a reference signal to a Low Noise Block
Converter (LNB), and passing the LNB's L-Band
output to the modem's Rx input.

Figure 2-4. LPOD Ground Connectors

2–8
Revision 9
MN-LPOD