Comtech EF Data TRP1000-OD Installation And Operation Manual page 91

Command
(Instruction
Parameter
Type Code and
or Response
Qualifier)
Reboot RBT= 1 byte
Retrieve N/A
Configuration
Status
Retrieve N/A 22 bytes
Equipment
Type
Serial-based Remote Product Management
Arguments
for
Description of Arguments
Command (Note that all arguments are ASCII
numeric codes between 48 and 57)
to Query
Command only.
Soft Reboot
1 = Reboot System
Example:
<1/RBT=1
Query only.
Used to query the configuration status of the unit.
Where:
AMP= RF Power Amplifier State
0=OFF, 1=ON
MUT=RF Mute State
0=Un-muted, 1=Muted, 2=Aux Muted
AFR= Auto Fault recovery
0=Manual, 1=Auto
LRS= see LRS command.
Example:
RCS='cr'
AMP=1'cr'
MUT=1'cr'
AFR=1'cr''lf'
LRS=3'cr''lf'
Query only.
The unit returns a string indicating the Model Number and
the version of the M&C firmware installed in the unit.
Example:
<1/RET?'cr'
>0001/RET= TRP1000-4450-C VER: 1.1.1'cr''lf'
TRP1000-4450 Troposcatter C-Band Outdoor Amplifier
Response to
Command
(Target to
Controller)
RBT =
RBT?
RBT*
RCS=
RET=
5–23
Revision 0
Query Response
(Instruction to Query
Code and (Target to
Qualifier) Controller)
N/A RBT=x
(See
description
for details of
arguments)
RCS? RCS=x....x
(See
description
for details of
arguments)
RET? RET=x....x
(See
description
for details of
arguments)
MN-TRP1000-OD