Alcatel-Lucent 5620 Troubleshooting Manual page 110

3 — Troubleshooting using network alarms
Alarm
Name: TunnelAdministrativelyDown
Type: pathAlarm (12)
Probable cause:
tunnelAdministrativelyDown (333)
Name: TunnelDown
Type: pathAlarm (12)
Probable cause: tunnelDown (23)
(3 of 3)
Alarm
Name: CrossconnectDown
Type: CrossconnectAlarm (60)
Probable cause: crossconnectDown (520)
Name: EcIdRxTxOrMacModified
Type: configurationAlarm (11)
Probable cause: ecIdRxTxOrMacModified
(568)
Name: InSufficientBandwidth
Type: communicationsAlarm (4)
Probable cause: inSufficientBandwidth
(521)
Name: LCD
Type: communicationsAlarm (4)
Probable cause: lossOfCellDelineation (569)
Name: LIF
Type: communicationsAlarm (4)
Probable cause: lossOfIMAFrame (570)
Name: LODS
Type: communicationsAlarm (4)
Probable cause: lossOfDelaySynchronization
(571)
(1 of 2)
3-68
Attributes
Severity: Minor
Object Type (class): Tunnel
Domain: mpls
Implicitly cleared (self-clearing): Yes
Severity: Warning
Object Type (class): Tunnel
Domain: mpls
Implicitly cleared (self-clearing): Yes
Table 3-42 Domain: mpr
Attributes
Severity: Major
Object Type (class): Crossconnect
Domain: mpr
Implicitly cleared (self-clearing): Yes
Severity: Minor
Object Type (class): MprVll
Domain: mpr
Implicitly cleared (self-clearing): No
Severity: Major
Object Type (class):
VlanPathInstance
Domain: mpr
Implicitly cleared (self-clearing): Yes
Severity: Major
Object Type (class): IMALink
Domain: mpr
Implicitly cleared (self-clearing): Yes
Severity: Major
Object Type (class): IMALink
Domain: mpr
Implicitly cleared (self-clearing): Yes
Severity: Major
Object Type (class): IMALink
Domain: mpr
Implicitly cleared (self-clearing): Yes
Alcatel-Lucent 5620 Service Aware Manager, Release
Aug 2010
Troubleshooting Guide
Additional information
The alarm is raised when the
5620 SAM detects that an MPLS path
is administratively down.
The alarm is raised when an MPLS
path has an Operational State other
than Up, and the Administrative
State is Up.
Additional information
The alarm is raised when the
Operational State of an L2 or L3
interface is Down, and the
Administrative State of the
associated site is Up.The alarm is not
raised against an L2 access interface
that is in the MC ring standby state.
The alarm is raised when something
other than the 5620 SAM deletes a
service cross-connect and creates a
new service cross-connect whose
MAC address, EC ID Rx, or EC ID Tx
value does not match the value in the
original service.
The alarm is raised when there is
insufficient bandwidth on a radio link
between hops in a service.
The alarm is raised when a Loss of
Cell Delineation signal is detected on
an ASAP MDA.
The alarm is raised when a Loss of
IMA Frame signal is detected on an
ASAP MDA.
The alarm is raised when a Loss of
Delay Synchronization signal is
detected on an ASAP MDA.
3HE 05723 AAAD TQZZA Edition 01
8.0 R4