Alcatel-Lucent 7210 SAS M OS Quality Of Service Manual page 393

percent — The percentage of the resrved and shared buffer space for the buffer pool at which the drop starts.
Parameters
The value entered must be lesser or equal to the current setting of max-avg. If the entered value is
greater than the current value of max-avg, an error will occur and no change will take place.
Values
time-average-factor
Syntax time-average-factor value
no time-average-factor
Context config>qos>slope-policy>queue
This command sets a weighting factor to calculate the new shared buffer average utilization after
Description
assigning buffers for a packet entering a queue. To derive the new shared buffer average
utilization, the buffer pool takes a portion of the previous shared buffer average and adds it to the
inverse portion
of the instantaneous shared buffer utilization. The time-average-factor command sets the
weighting factor between the old shared buffer average
utilization and the current shared buffer instantaneous utilization when calculating the new shared
buffer average utilization.
The TAF value applies to all high ,low priority and non-tcp packets WRED slopes for egress
access and network buffer pools controlled by the slope policy.
7210 SAS M OS Quality of Service Guide
0 — 100
Operational Commands
Page 417