Alcatel-Lucent 7210 SAS M OS Quality Of Service Manual page 339

Default no remarkingIf remarking is enabled by default, 'use-dot1p' is used. Dot1p and DSCP values are marked
according to Table 46 on page 348Remarking is disabled by default.
use-dot1p — If use-dot1p is configured, then for all the FCs only the configured dot1p values will be used.
Parameters
use-dscp — If use-dscp is configured, then for all the FCs only the configured dscp values are used.
all — If all is configured, then for all the FCs both the dot1p and dscp values configured is used (if both
have been provided).
scope
Syntax scope {exclusive | template}
no scope
Context config>qos>access-egress
This command configures the scope as exclusive or template. The policy's scope cannot be
Description
changed if the policy is applied to multiple ports.
The no form of this command sets the scope of the policy to the default of template.
template
Default
exclusive — When the scope of a policy is defined as exclusive, the policy can only be applied to one port.
Parameters
If a policy with an exclusive scope is assigned to a second interface an error message is generated. If the
policy is removed from the exclusive interface, it will become available for assignment to another
exclusive interface.
The system default policies cannot be put into the exclusive scope. An error will be generated if scope
exclusive is executed in default access-egress policy (policy-id 1).
template — When the scope of a policy is defined as template, the policy can be applied to multiple ports
on the router.
Default QoS policies are configured with template scope. An error is generated if you try to modify the
scope parameter from template to exclusive scope on default policies.
7210 SAS M OS Quality of Service Guide Page 363