Alcatel-Lucent 7210 SAS M OS Quality Of Service Manual page 144

Network QoS Policy Commands
When ldp-use-local-fc-enable is set, system does not create the mpls-lsp-exp-profile-map policies
by default (except for the default policy "1"). User is allowed to create, delete, modify, copy the
policies. User needs to associate these policies with appropriate network policies as per their
requirement.
1 (default mpls-lsp-exp-profile-map policy "1").
Default
policy-id — The policy-id uniquely identifies the policy on the 7210 SAS.
Parameters
Values
create — The keyword used to create a policy.
lsp-exp
Syntax lsp-exp lsp-exp-value profile {in|out}
no lsp-exp
Context config>qos> mpls-lsp-exp-profile-map
This command creates a mapping between the LSP EXP bits of the network ingress traffic and the
Description
profile.
Ingress traffic that matches the specified LSP EXP bits will be assigned the corresponding profile.
Multiple commands can be entered to define the association of some or all eight LSP EXP bit
values to the profile. For undefined values, packets are assigned the profile value out.
The no form of this command removes the association of the LSP EXP bit value to the profile
value. The default profile value 'out' then applies to that LSP EXP bit pattern.
none
Default
lsp-exp-value — The 3-bit LSP EXP bit value, expressed as a decimal integer.
Parameters
Values
profile — Assign the profile value to be assigned to this LSP EXP value.
Default
Values
Page 152
1— 65535
0 — 7
None, the lsp-exp command must define a profile state.
Values in, out
7210 SAS M OS Quality of Service Guide