Alcatel-Lucent 7210 SAS M OS Quality Of Service Manual page 334

mark Dot1p on an egress access port for the in and out of profile packets. If the user has not
explicitly configured this FC-Dot1p map the marking of packets is according to FC-Dot1P
marking table as listed in
User can explicitly define the new Dot1P values using these commands.
The no form of the command sets the IEEE 802.1P or IEEE 802.1Q priority bits to default FC-
Dot1P marking map as listed in
page 61.
dot1p-value — This value specifies the unique IEEE 802.1P value that will match the dot1p rule. If the
Parameters
command is executed multiple times with the same dot1p-value, the previous forwarding class and
enqueuing priority is completely overridden by the new parameters or defined to be inherited when a
forwarding class or enqueuing priority parameter is missing.
A maximum of eight dot1p rules are allowed on a single policy.
Values
dscp-out-profile
Syntax dscp-out-profile dscp-name
no dscp-out-profile
Context config>qos>access-egress>fc
This command specifies the out-of-profile DSCP name for the forwarding class. The
Description
corresponding DSCP value will be used for all IP packets requiring marking the egress on this
forwarding class queue that are out-of-profile.
When multiple DSCP names are associated with the forwarding class at network egress, the last
name entered will overwrite the previous value.
The no form of this command reverts to the factory default out-of-profile dscp-name.
Parameters
dscp-name —
Values
Page 358
Table 26, Default SAPAccess Egress Policy ID 1 Definition, on page
Table 26, Default SAPAccess Egress Policy ID 1 Definition, on
0 — 7
Specifies the DSCP name.
be|cp1|cp2|cp3|cp4|cp5|cp6|cp7|cs1|cp9|af11|cp11|
af12|cp13|af13|cp15|cs2|cp17|af21|cp19|af22|cp21|
af23|cp23|cs3|cp25|af31|cp27|af32|cp29|af33|cp31|cs4|
cp33|af41|cp35|af42|cp37|af43|cp39|cs5|cp41|cp42|
cp43|cp44|cp45|ef|cp47|nc1|cp49|cp50|cp51|cp52|cp53|
cp54|cp55|nc2|cp57|cp58|cp59|cp60|cp61|cp62|cp63
7210 SAS M OS Quality of Service Guide
61.