Alcatel-Lucent 7210 SAS M OS Quality Of Service Manual page 341

Show Commands
access-egress
Syntax access-egress [policy-id] [association | detail]
Context show>qos
This command displays Access egress QoS policy information.
Description
policy-id — Displays information about the specific policy ID. Displays all access-egress policies if no
Parameters
specific policy-id is entered.
Values
association — Displays a list of ports on which the policy is applied.
detail — Displays detailed policy information including policy associations.
Access Egress Output — The following table describes Access egress show command output.
Policy-Id
Remark
Description
Forward Class/FC
Name
Explicit/Default
7210 SAS M OS Quality of Service Guide
1 — 65535
Label
The ID that uniquely identifies the policy.
True — Remarking is enabled for all packets that egress this
router where the access egress QoS policy is applied.
True — Remarking is enabled for all the Dot1q-tagged packets
that egress the ports where the access-egress QoS policy is
applied and remarking is enabled.
The remarking is based on the forwarding class to explicit
Dot1P bit mapping defined under the fc name. If explicit map-
ping FC-Dot1P map not defined marking is based on the default
FC-Dot1P marking map as defined in
cess Egress Policy ID 1 Definition, on page
False — Remarking is disabled for the policy.
A text string that helps identify the policy's context in the con-
figuration file
Specifies the forwarding class to Dot1p remarking value.
Explicit — Specifies the egress IEEE 802.1P (dot1p) bits mark-
ing for fc-name if explicitly configured.
Description
Table 26, Default SAPAc-
61.
Page 365