Alcatel-Lucent 7210 SAS M OS Quality Of Service Manual page 161

Network Egress QoS Policy Commands
egress
Syntax egress
Context config>qos>network policy-id
This command is used to enter the CLI node that creates or edits egress policy entries that specify
Description
the forwarding class to marking map to be instantiated when this policy is applied to the network
IP interface, network port or access-uplink port.
The forwarding class and profile state mapping to appropriate marking values for all packets are
defined in this context.
In network mode of operation, the system supports use of forwarding class mapping to EXP bits
for IP interface, forwarding class mapping to DSCP and Dot1p bits for network ports. In access-
uplink mode of operation it allows the user to specify the FC mapping to Dot1p bits for access-
uplink ports.
All out-of-profile service packets are marked with the corresponding out-of-profile value at
network egress. All the in-profile service ingress packets are marked with the corresponding in-
profile value based on the forwarding class they belong.
fc
Syntax [no] fc fc-name
Context config>qos>network>egress
This command specifies the forwarding class name. The forwarding class name represents an
Description
egress queue. The fc fc-name represents a CLI parent node that contains sub-commands or
parameters describing the marking criteria of packets flowing through it. The fc command
overrides the default parameters for that forwarding class to the values defined in the network
default policy. Appropriate default parameters are picked up based on whether the network-policy-
type is port or ip-interface.
The no form of this command removes the forwarding class LSP EXP/Dot1p/DSCP map
associated with this fc, as appropriate. The forwarding class reverts to the defined parameters in
the default network policy. If the fc-name is removed from the network policy that forwarding
class reverts to the factory defaults.
Undefined forwarding classes default to the configured parameters in the default network policy
Default
policy-id 1.
7210 SAS M OS Quality of Service Guide
Operational Commands
Page 169