Alcatel-Lucent 7210 SAS M OS Quality Of Service Manual page 388

Slope Policy QoS Policy Commands
Slope Policy QoS Policy Commands
queue
Syntax queue queue-id
Context config>qos>slope-policy
This command sets the context to configure the high-priority, low-priority, and non-tcp slope
Description
parameters per queue.
Parameters
queue-id —
Values
high-slope
Syntax [no] high-slope
Context config>qos>slope-policy>queue
The high-slope context contains the commands and parameters for defining the high priority
Description
Random Early Detection (RED) slope graph. Each buffer pool supports a high priority RED slope
for managing access to the shared portion of the buffer pool for high priority or in-profile packets.
The high-slope parameters can be changed at any time and the affected buffer pool high priority
RED slopes will be adjusted appropriately.
The no form of this command restores the high slope configuration commands to the default
values. If the commands within high-slope are set to the default parameters, the high-slope node
will not appear in save config and show config output unless the detail parameter is present.
low-slope
Syntax [no] low-slope
Context config>qos>slope-policy
config>qos>slope-policy>queue
The low-slope context contains the commands and parameters for defining the low priority
Description
Random Early Detection (RED) slope graph. Each buffer pool supports a low priority RED slope
for managing access to the shared portion of the buffer pool for low priority or out-of-profile
packets.
Page 412
Specifies the ID of the queue for which the drop-rate is to be configured.
1 — 8
7210 SAS M OS Quality of Service Guide