Alcatel-Lucent 7210 SAS M OS Quality Of Service Manual page 336
Hide thumbs
Also See for 7210 SAS M OS:
- Service manual (952 pages) ,
- Configuration manual (558 pages) ,
- Interface configuration manual (347 pages)
Table of Contents
Advertisement
Access Egress Queue QoS Policy Commands
adaptation-rule
Syntax
adaptation-rule [cir adaptation-rule] [pir adaptation-rule]
no adaptation-rule
Context
config>qos>access-egress>queue
This command defines the method used by the system to derive the operational CIR and PIR
Description
settings when the queue is provisioned in hardware. For the CIR and PIR parameters individually,
the system attempts to find the best operational rate depending on the defined constraint.
The no form of the command removes any explicitly defined constraints used to derive the
operational CIR and PIR created by the application of the policy. When a specific adaptation-rule
is removed, the default constraints for cir and pir apply.
adaptation-rule pir closest cir closest
Default
adaptation-rule — Specifies the adaptation rule to be used while computing the operational CIR or PIR
Parameters
value.
Values
Page 360
pir — Defines the constraints enforced when adapting the PIR rate defined within the
queue queue-id rate command. The pir parameter requires a qualifier that defines the
constraint used when deriving the operational PIR for the queue. When the rate command
is not specified, the default applies.
cir — Defines the constraints enforced when adapting the CIR rate defined within the
queue queue-id rate command. The cir parameter requires a qualifier that defines the
constraint used when deriving the operational CIR for the queue. When the cir parameter
is not specified, the default constraint applies.
max — The max (maximum) option is mutually exclusive with the min and closest
options. When max is defined, the operational PIR for the queue will be equal to or less
than the administrative rate specified using the rate command.
min — The min (minimum) option is mutually exclusive with the max and closest
options. When min is defined, the operational PIR for the queue will be equal to or greater
than the administrative rate specified using the rate command.
closest — The closest parameter is mutually exclusive with the min and max parameter.
When closest is defined, the operational PIR for the queue will be the rate closest to the
rate specified using the rate command.
7210 SAS M OS Quality of Service Guide
Advertisement
Table of Contents
