Alcatel-Lucent 7210 SAS M OS Quality Of Service Manual page 111

User has an option to specify the mapping of the LSP EXP bits to a profile (in/out). Ingress traffic
that matches the specified EXP bits will be assigned the corresponding profile.
To create an network QoS policy of type port when oprating in network mode, define the
following:
•
•
•
•
•
To create an network QoS policy of type port when operating in access-uplink mode, define the
following:
•
•
•
•
7210 SAS M OS Quality of Service Guide
A network policy ID value. The system will not dynamically assign a value.
Set the network-policy-type parameter to 'port'
Include a description. The description provides a brief overview of policy features.
You can modify egress DSCP and Dot1p marking map. Otherwise, the default values are
applied.
→ Remarking — When enabled, this command remarks ALL packets that egress on the
specified network port. The remarking is based on the forwarding class to DSCP bit
mapping defined under the egress node of the network QoS policy for all IP traffic and
forwarding class to Dot1p bit mapping for all IP and MPLS traffic.
→ Forwarding class criteria — The forwarding class name represents an egress queue.
Specify forwarding class criteria to definethe marking criteria of packets flowing
through it.
→ DSCP and Dot1p — The DSCP and Dot1p value is used for all packets requiring
marking that egress on this forwarding class queue that are in or out of profile.
Ingress criteria — Specifies either DSCP or Dot1p (but not both) to forwarding class
mapping for all packets.
→ Default action — Defines the default action to be taken for packets that have an
undefined DSCP or Dot1p bits set. The default-action specifies the forwarding class to
which such packets are assigned.
→ DSCP or Dot1p — Creates a mapping between the DSCP or Dot1p bits of the network
ingress traffic and the forwarding class. Ingress traffic that matches the specified
DSCP or Dot1p bits will be assigned to the corresponding forwarding class.
A network policy ID value. The system will not dynamically assign a value.
Set the network-policy-type parameter to 'port'
Include a description. The description provides a brief overview of policy features.
You can modify egress Dot1p marking map. Otherwise, the default values are applied.
→ Remarking — When enabled, this command remarks ALL packets that egress on the
specified network port. The remarking is based on the forwarding class to Dot1p bit
mapping.
Network QoS Policies
Page 119