Alcatel-Lucent 7210 SAS M OS Quality Of Service Manual page 140

Generic Commands
Operational Commands
copy
Syntax copy network src-pol dst-pol [overwrite]
Context config>qos
This command copies existing QoS policy entries for a QoS policy-id to another QoS policy-id.
Description
The copy command is used to create new policies using existing policies and also allows bulk
modifications to an existing policy with the use of the overwrite keyword.
Note: In "no ldp-local-fc-enable" mode, when an ip-interface qos policy is copied, a new mpls-
lsp-exp-profile-map is created with the id same as dest-policy id and the mpls-lsp-exp-profile of
the dest-policy points to it. In "ldp-local-fc-enable" mode, when an ip-interface qos policy is
copied, the mpls-lsp-exp-profile of the dest-policy points to the mpls-lsp-exp-profile-map pointed
to by the source-policy.
network src-pol dst-pol — Indicates that the source and destination policies are network policy IDs.
Parameters
Specify the source policy that the copy command will copy and specify the destination policy to which
the command will duplicate the policy to a new or different policy ID.
Values
overwrite — Specifies to replace the existing destination policy. Everything in the existing destination
policy will be overwritten with the contents of the source policy. If overwrite is not specified, an error
will occur if the destination policy ID exists.
SR>config>qos# copy network 1 427
MINOR: CLI Destination "427" exists use {overwrite}.
SR>config>qos# copy network 1 427 overwrite
scope
scope {exclusive | template}
Syntax
no scope
Context config>qos>network policy-id
This command configures the network policy scope as exclusive or template.
Description
The no form of this command sets the scope of the policy to the default of template.
template
Default
Page 148
1 — 65535
7210 SAS M OS Quality of Service Guide