Alcatel-Lucent 7210 SAS M OS Quality Of Service Manual page 332

egressing out of the port with either dot1p or dscp or both (that is, both dot1p and dscp). If
remarking is enabled and the remark policy is of type 'dot1p' or 'dot1p-lsp-exp-shared' then the
dot1p bits are marked in the packet based on the FC to dot1p values specified in the remark policy.
If remarking is enabled and the remark policy is of type 'dscp' then the IP DSCP bits are marked
in the packet. If remarking is enabled and the remark policy is of type 'dot1p-dscp' then both
dot1p and IP DSCP bits are marked in the packet.
Note: When port-based marking is enabled and marking for both dot1p and IP DSCP bits is
configured, the system marks dot1p and IP DSCP bits for all the packets sent out of both L2 SAPs
and L3 SAPs. It is recommended that if both L2 and L3 SAPs are configured on the same port,
then remark policy of type dot1p, that marks only dot1p bits be used.
The no form of this command deletes the access-egress policy. A policy cannot be deleted until it
is removed from all access ports where it is applied. When an access-egress policy is removed
from an access port, the access port will revert to the default access-egress policy-id 1.
This command is used to create or edit a access egress QoS policy. The egress policy defines the
queue parameters (CIR/PIR) for each of the forwarding class traffic as they egress on the access
port. Policies in effect are templates that can be applied to multiple access ports as long as the
scope of the policy is template. There are 8 queues always available per port for which parameters
are configurable.
policy-id — The value that uniquely identifies the access-egress policy.
Parameters
Values
create — The keyword used to create an access-egress policy. The create keyword requirement can be
enabled/disabled in the environment>create context.
fc
Syntax fc fc-name [create]
no fc fc-name
Context config>qos>access-egress
This command defines the fc node within the access egress QoS policy is used to contain the
Description
explicitly defined Dot1p marking commands for the fc-name.
Note that when the mapping for the fc-name and Dot1p marking is not defined, the node for fc-
name is not displayed in the show configuration or save configuration output.
The no form of the command removes the explicit Dot1p marking commands for the fc-name.
fc-name — Specifies the forwarding class for which Dot1p marking is to be edited. The value given for fc-
name must be one of the predefined forwarding classes in the system.
Values
Page 356
1 — 65535
be, l2, af, l1, h2, ef, h1, nc
7210 SAS M OS Quality of Service Guide