Alcatel-Lucent 7210 SAS M OS Quality Of Service Manual page 166

Network Egress QoS Policy Forwarding Class Commands
lsp-exp-out-profile
Syntax lsp-exp-out-profile lsp-exp-value
no lsp-exp-out-profile
Context config>qos>network policy-id>egress>fc fc-name
This command specifies the out-of-profile LSP EXP value for the forwarding class. The EXP
Description
value will be used for all LSP labeled packets requiring marking the egress on this forwarding
class queue that are out-of-profile.
When multiple EXP values are associated with the forwarding class at network egress, the last
name entered will overwrite the previous value.
The no form of this command reverts to the factory default out-of-profile EXP setting.
Policy-id 2:
Default
Policy-id 3 — 65535:
mpls-exp-value — The 3-bit MPLS EXP bit value, expressed as a decimal integer.
Parameters
Default
Values
remarking
Syntax [no] remarking
Context config>qos>network policy-id>egress
This command remarks network egress traffic. The remarking is based on the forwarding class to
Description
LSP EXP/Dot1p/DSCP bit mapping defined under the egress node of the network QoS policy in
network mode. In access-uplink mode, the remarking is based on the forwarding class to Dot1p bit
mappings defined under the egress node of the network QoS policy.
On network egress in network mode, for MPLS packets, only LSP EXP and Dot1p values can be
marked. The LSP EXP mapping is defined in the network policy of type ip-interface and the
Dot1p mapping can be defined in the network policy of type port.
On network egress in network mode, for IP packets, DSCP and Dot1p values can be marked. The
Dot1p and DSCP values can be configured in the network policy of type port.
Normally, packets that ingress on network ports have, in case of MPLS packets, LSP EXP bit set
by an upstream router. The packets are placed in the appropriate forwarding class based on the
LSP EXP to forwarding class mapping. The LSP EXP bits of such packets are not altered as the
packets egress this router, unless remarking is enabled.
Page 174
Factory setting
Policy-id setting
none
0 — 7
7210 SAS M OS Quality of Service Guide