Alcatel-Lucent 7210 SAS M OS Quality Of Service Manual page 160

Network Ingress QoS Policy Commands
rate
Syntax rate cir cir-rate-in-kbps [pir pir-rate-in-kbps]
no rate
Context config>qos>network>ingress>meter
This command defines the administrative PIR and CIR parameters for the meter.
Description
The rate command can be executed at anytime, altering the PIR and CIR rates for all meters
created through the association of the Network QoS policy with the meter-id.
The no form of the command returns all meter instances created with this meter-id to the default
PIR and CIR parameters (max, 0).
rate 0 pir max — The max default specifies the amount of bandwidth in kilobits per second
Default
(thousand bits per second). The max value is mutually exclusive to the pir-rate value.
cir cir-rate-in-kbps — The cir parameter overrides the default administrative CIR used by the meter. When
Parameters
the rate command has not been executed or the cir parameter is not explicitly specified, the default CIR
(0) is assumed.
Values
pir pir-rate-in-kbps — Defines the administrative PIR rate, in kilobits, for the meter. When this rate
command is executed, the PIR setting is optional.When the rate command has not been executed, the
default PIR of max is assumed.
Fractional values are not allowed and must be given as a positive integer.
The actual PIR rate is dependent on the meter's adaptation-rule parameters and the actual hardware
where the meter is provisioned.
Values
Page 168
0 — 20000000, max
— 20000000, max
7210 SAS M OS Quality of Service Guide