Tabletop Installation; Installing A Power Supply In A 2370 Or 2380 Switch - Nortel 2350 Installation And Basic Configuration Manual

46 Installing and Connecting a WLAN—Security Switch
5
Lift the WSS into position in the equipment rack.
Warning!
switch until all the rack-mount screws are tight. (For translations of this
warning, see
6
Insert the bottom rack-mount screws into the bracket flanges to secure the WSS to the equipment rack,
then insert the top screws.
7
Do one of the following:
●
If you are installing a second power supply into a 2370 or 2380 switch, go to
Supply in a 2370 or 2380 Switch" on page
●
If you are ready to turn on power, go to "Powering On a WSS" on page 48.

Tabletop Installation

1
On a clean work surface with no debris, carefully turn the WSS upside down.
2
Wipe the four placement locations for the rubber feet to clear away any oil or dust. The location areas are
marked by X's.
3
Attach the four rubber adhesive feet over the X's.
4
Turn the WSS right-side up, and place the switch in position on the table.
5
Do one of the following:
●
If you are installing a second power supply into a WSS-2370 or 2380 switch, go to
Power Supply in a 2370 or 2380
●
If you are ready to turn on power, go to "Powering On a WSS" on page 48.

Installing a Power Supply in a 2370 or 2380 Switch

A 2370 or 2380 switch is shipped with a single 100-240 VAC autosensing AC power supply. One power supply
provides enough power for a fully configured system. You can add a second power supply for load sharing and redun-
dancy. A WSS containing one power supply can have the supply installed in either slot. If the switch contains two power
supplies and one supply fails, the other supply automatically takes over to provide uninterrupted operation.
The power supplies are hot-swappable. You can remove or insert a power supply while the other power supply is
running.
Use the following procedures to install a second power supply or replace a failed power supply.
(You cannot insert or remove power supplies in a 2360 switch.)
Note.
To attach the power supply to an 2350, see
320656-A
To prevent the WSS from slipping, do not release the
"Rack Installation Warnings" on page
Switch".
166.)
46.
"Powering On a 2350" on page
"Installing a Power
"Installing a
49.