Nortel 2350 Installation And Basic Configuration Manual page 140

140 Configuring a 2350 Switch for a Branch Office
Table 12: Configuration Parameter List (continued)
Configuration
Parameters
12. Service Set Identifier
(SSID) name
13. Is the SSID encrypted?
14. Encryption settings for
the SSID
15. AP model and serial
numbers
320656-A
CLI Commands
set service-profile name ssid-name ssid-name
show service-profile name
set service-profile name ssid-type [clear | crypto]
show service-profile name
To configure static WEP:
set service-profile name wep key-index num key value
set service-profile name wep active-multicast-index num
set service-profile name wep active-unicast-index num
To enable WPA with TKIP:
set service-profile name wpa-ie enable
To enable WPA with AES/CCMP:
set service-profile name cipher-ccmp enable
To enable WPA and WEP:
set service-profile name cipher-wep104 enable
or
set service-profile name cipher-wep40 enable
Note: Microsoft Windows XP does not support WEP with WPA. To
configure a service profile to provide WEP for XP clients, leave WPA
disabled.
show service-profile name
For a directly connected AP:
set port type ap port-list model model-num poe enable
show ap config
For a Distributed AP:
set dap dap-num serial-id serial-ID model model-num
show dap config