Nortel 2350 Installation And Basic Configuration Manual page 28

28 WLAN—Security Switch Overview
Table 2: WSS Status LEDs—2370, 2360, 2380 (continued)
LED
AP
(2370 and 2360 only)
2350 LEDs
Figure 8 on page 28 shows the locations of the 2350 LEDs.
Figure 8. 2350 LEDs
LED
Power status
320656-A
Appearance
Solid green
Alternating green and
amber
Solid amber
Blinking amber
Unlit
Factory Reset
AP LED
LED
1
2
Link LED
Table 3: WSS Status LEDs—2350
Appearance
Solid green
Unlit
Meaning
For an AP access point's active link, with
PoE enabled, all the following are true:
• AP access point has booted.
• AP access point has received a valid
configuration from the WSS.
• Management link with an AP access
point is operational.
AP access point is booting with an image
received from the WSS.
If the LED remains in this state indefinitely,
the boot or configuration attempt has failed.
PoE is on but no AP access point is
connected to the link.
AP is not connected or is unresponsive, or
there is a PoE problem.
Port is not configured as an AP access port,
or PoE is off.
Table 3 describes the LEDs.
Power
supply LED
Meaning
The switch is receiving power.
The switch is not receiving power.