Nortel 2350 Installation And Basic Configuration Manual page 105

After the AP contacts the WSS, the WSS relays information about WSSs in the network that contain a
Distributed AP configuration specific to that Distributed AP.
Caution!
device. If you enable PoE under other conditions, power can damage the device.
Configuring for a Directly-Connected AP
Caution!
specify the PoE state (enabled or disabled) of the port. If you enable PoE on a port
connected to another device, physical damage to the device can result.
To set a port for a locally-connected AP, use the following command:
set port type ap port-list
model {AP2750 | mp-52 | mp-101 | mp-122 | mp-241 | mp-252 | mp-262 |
mp-341 | mp-352 | 2330}
poe {enable | disable}
[radiotype {11a | 11b| 11g}]
You must specify a port list of one or more port numbers, the AP model number, and the PoE state.
AP access point models AP2750, MP-241 and MP-341 have a single radio that can be configured for 802.11a or
802.11b/g. Other AP models have two radios. One radio is always 802.11a. The other radio is 802.11b/g, but can be
configured for 802.11b or 802.11g exclusively. If the country of operation specified by the set system countrycode
command does not allow 802.11g, the default is 802.11b.
Note.
are still supported by the command.
AP radios configured for 802.11g also allow associations from 802.11b clients by default. To disable support for
802.11b associations, use the set radio-profile 11g-only command on the radio profile that contains the radio.
Note.
You cannot configure any gigabit Ethernet port, or port 7 or 8 on an 2360 switch,
as an AP point. To manage an AP access point on a 2380 switch, configure a Distributed
AP connection on the switch. (See
AP model MP-262 requires an external antenna for the 802.11b/g radio. AP-3xx models have an internal 802.1b/g
antenna as well as a connector for an external antenna, so use of an external antenna is optional on these models. The
2330 also has a connector for an optional external 802.11a antenna. To specify the antenna model, use the set {ap | dap}
radio antennatype command. (See
WLAN—Security Switch 2300 Series Installation and Basic Configuration Guide
Configuring a 2370, 2360, or 2380 Switch for Basic Service 105
Do not enable PoE on network ports unless you intend to power a third-party
When you set the port type for use by locally connected APs, you must
All AP models except the 2330 and AP2750 have been discontinued but
"Configuring for a Distributed AP" on page
"Configuring Radio-Specific Parameters" on page
106.)
112.)