Displaying And Saving The Configuration; Verifying Operation - Nortel 2350 Installation And Basic Configuration Manual

142 Configuring a 2350 Switch for a Branch Office
Table 12: Configuration Parameter List (continued)
Configuration
Parameters
21. Authentication \
authorization rules

Displaying and Saving the Configuration

The 2350 immediately implements configuration changes by updating the device's running configuration.
However, the software does not automatically retain configuration changes after a software reboot or a power
cycle. To review and save configuration changes, use the following commands:
show config
save config

Verifying Operation

The following sections describe how to verify IP connectivity between the 2350 and other devices in the
network, and how to verify wireless user sessions.
320656-A
CLI Commands
To use the local database to authenticate and authorize network access
to an encrypted SSID by Microsoft 802.1X clients:
set authentication dot1x ssid ssid-name ** [bonded]
peap-mschapv2 local
To use the local database to authenticate and authorize network
access to an unencrypted SSID by WebAAA clients:
set authentication web ssid ssid-name ** local
show aaa
The * and *.* values are wildcards that match on any username. (For
information, see the "User Wildcards, MAC Address Wildcards, and
VLAN Wildcards" section in the "Using the Command-Line Interface"
chapter of the Nortel WLAN 2300 System Software Configuration
Guide.)
Note: To use a RADIUS server group to authenticate access, specify
the server group name instead of local. (You also can specify a server
group name and local, in either order, to provide a backup method.)
(For the syntax to authenticate MAC or last-resort users, see the
"Configuring AAA for Network Users" chapter of the Nortel WLAN
2300 System Software Configuration Guide.
To configure authentication rules for administrative access, see the
"Configuring AAA for Administrative and Local Access" chapter of
the same guide.)