Nortel 2350 Installation And Basic Configuration Manual page 107

The model and radiotype parameters have the same options as they do with the set port type ap command.
Because the WSS does not supply power to an indirectly connected AP, the set dap command does not use the
poe parameter.
Note.
You can configure an AP configuration template for automatically configuring
Distributed APs when they boot using the WSS. For information, see the "Configuring a
Template for Automatic AP Configuration" section of the "Configuring AP Access Points"
chapter in the Nortel Mobility System Software Configuration Guide.
The following example configures connections for two Distributed APs that are indirectly connected to the
WSS. Note that when you create a connection, you assign it a number that can be used later for displaying and
configuration, much like the physical ports for directly connected APs:
2370# set dap 1 serial-id 0322199999 model 2330
success: change accepted.
2370# set dap 2 serial-id 0322199998 model 2330
success: change accepted.
To verify the configuration change, use the following command:
show dap config [dap-num [radio {1 | 2}]]
Here is an example:
2370# show dap config
Dap 1: serial-id: 0322199999, AP model: 2330, bias: high, name: DMP01
fingerprint:
boot-download-enable: YES
load balancing group: none
Radio 1: type: 802.11g, mode: disabled, channel: dynamic
tx pwr: 14, profile: default
auto-tune max-power: default, min-client-rate: 5.5, max-retransmissions: 10
Radio 2: type: 802.11a, mode: disabled, channel: dynamic
tx pwr: 11, profile: default
auto-tune max-power: default, min-client-rate: 24, max-retransmissions: 10
Dap 2: serial-id: 0322199998, AP model: 2330, bias: high, name: DMP02
fingerprint:
boot-download-enable: YES
load balancing group: none
Radio 1: type: 802.11g, mode: disabled, channel: dynamic
tx pwr: 14, profile: default
auto-tune max-power: default, min-client-rate: 5.5, max-retransmissions: 10
Radio 2: type: 802.11a, mode: disabled, channel: dynamic
tx pwr: 11, profile: default
auto-tune max-power: default, min-client-rate: 24, max-retransmissions: 10
Configure the same Distributed AP on each of the WSSs you want to use to manage the AP access point asso-
ciated with the Distributed AP. Make sure to use the same Distributed AP number and serial ID on each WSS.
WLAN—Security Switch 2300 Series Installation and Basic Configuration Guide
Configuring a 2370, 2360, or 2380 Switch for Basic Service 107