Nortel 2350 Installation And Basic Configuration Manual page 86

86 Configuring a 2370, 2360, or 2380 Switch for Basic Service
Note.
To avoid confusion, do not assign numbers as VLAN names. Every VLAN on an
WSS has both a VLAN name used for authorization purposes and a VLAN number. VLAN
numbers can vary uniquely for each WSS and are not related to 802.1Q tag values even
when used. VLAN names must be unique among all WSSs in a Mobility Domain.
The following command displays VLAN information:
2370# show vlan config
VLAN Name
---- ---------------- ------ ----- ----- ---------------- ----- -----
1 default
2 mgmt
3 red
4 blue
Note.
The default VLAN listed in the sample show vlan output is present in a WSS's
configuration by default but does not contain any ports unless you add them. Nortel
recommends that you do not use the default VLAN (VLAN 1) for user traffic or rename the
default VLAN. Instead, configure other VLANs and use those VLANs for user traffic. This is
because the default VLAN might not be in the same subnet on each switch.
The following commands configure IP addresses on some of the VLANs. (WSS Software does not require an
IP address on every VLAN.)
2370# set interface mgmt ip 10.10.10.4/24
success: change accepted.
2370# set interface blue ip 10.10.20.2/24
success: change accepted.
2370# show interface
VLAN Name
---- --------------- --------------- --------------- ------- ----- ---------
2 mgmt
4 blue
320656-A
Admin VLAN Tunl
Status State Affin Port
Up Down
Up Down
Up Down
Up Down
Address Mask
10.10.10.4 255.255.255.0
10.10.20.2 255.255.255.0
5
5
5
5
5
5
5
Enabled State RIB
YES Up ipv4
YES Up ipv4
Port
Tag State
none Up
30 Up
20 Up