Tabletop Installation; Installing A Power Supply In A 2380 Switch - Nortel 2382 Configuration Manual

50 Installing and connecting a WSS
5
Lift the 2380 into position in the equipment rack.
Warning!
the rack-mount screws are tight.
6
Insert the bottom rack-mount screws into the bracket flanges to secure the 2380 to the
equipment rack, then insert the top screws.
7
Do one of the following:
• If you are installing a second power supply into a 2380 switch, go to
supply in a 2380 switch" on page
• If you are ready to turn on power, go to

Tabletop installation

1
On a clean work surface with no debris, carefully turn the WSS upside down.
2
Wipe the four placement locations for the rubber feet to clear away any oil or dust. The location
areas are marked by X's.
3
Attach the four rubber adhesive feet over the X's.
4
Turn the WSS right-side up, and place the switch in position on the table.
5
Do one of the following:
• If you are installing a second power supply into a 2380 switch, go to
supply in a 2380
• If you are ready to turn on power, go to

Installing a power supply in a 2380 switch

A 2380 switch is shipped with a single 100-240 ~AC autosensing AC power supply. One power supply
provides enough power for a fully configured system. You can add a second power supply for load sharing and
redundancy. A WSS containing one power supply can have the supply installed in either slot. If the switch
contains two power supplies and one supply fails, the other supply automatically takes over to provide uninter-
rupted operation.
The power supplies are hot-swappable. You can remove or insert a power supply while the other power supply
is running.
Use the following procedures to install a second power supply or replace a failed power supply.
(You cannot insert or remove power supplies in a 2360 and 2382 switch.)
Note.
To attach the power supply to a 2350, see
NN47250-301 (320656-E Version 02.01)
To prevent the WSS from slipping, do not release the switch until all
50.
"Powering on a WSS" on page
switch".
"Powering on a WSS" on page
"Installing a power
53.
"Installing a power
53.
"Powering on a 2350" on page 54.