Verifying Ip Connectivity - Nortel 2350 Installation And Basic Configuration Manual

Verifying IP Connectivity

To verify IP connectivity between the 2350 and another device, use the following command:
ping host
This command is supported on the 2350 and other Nortel switches, and is widely supported on third-party networking
devices and clients.
The ping command sends an Internet Control Message Protocol (ICMP) echo packet to the specified device and listens
for a reply packet. For host, specify the IP address of a host device on the network.
Enter this command from the 2350 to verify connection to other devices. Also enter this command on other devices such
as the local access router to verify connection to the 2350.
The following command verifies IP connectivity to IP address 10.10.20.19:
2370# ping 10.10.20.19
PING 10.10.20.19 (10.10.20.19) from 10.10.20.2 : 56(84) bytes of data.
64 bytes from 10.10.20.19: icmp_seq=1 ttl=255 time=0.769 ms
64 bytes from 10.10.20.19: icmp_seq=2 ttl=255 time=0.628 ms
64 bytes from 10.10.20.19: icmp_seq=3 ttl=255 time=0.676 ms
64 bytes from 10.10.20.19: icmp_seq=4 ttl=255 time=0.619 ms
64 bytes from 10.10.20.19: icmp_seq=5 ttl=255 time=0.608 ms
--- 20.20.20.1 ping statistics ---
5 packets transmitted, 5 packets received, 0 errors, 0% packet loss
WLAN—Security Switch 2300 Series Installation and Basic Configuration Guide
Configuring a 2350 Switch for a Branch Office 143