Nortel 2350 Installation And Basic Configuration Manual page 45

Figure 11. 2370 or 2380 Installation—Center-Mount Equipment Rack
First, attach brackets to chassis.
Then, install chassis into rack.
1
Remove the four bracket screws from each side of the WSS.
2
Align a bracket over the screw holes:
●
For a front-mount equipment rack, align the bracket so that the bracket flange is flush with the
WSS's front panel and extends away from the switch.
●
For a center-mount equipment rack, align the bracket so that the bracket flange is located near the
center screw holes.
3
Reinsert the screws to secure the brackets to the WSS.
4
Repeat for the other bracket.
Warning!
with the remaining steps. If you accidentally drop the WSS, you can be
injured and the switch can be damaged. (For translations of this
warning, see
WLAN—Security Switch 2300 Series Installation and Basic Configuration Guide
Installing and Connecting a WLAN—Security Switch 45
Nortel recommends that you ask someone to assist you
"Rack Installation Warnings" on page 166.)